|D400HS||100mm | Humidity sensor | Pull cord|
|D400HT||100mm | Humidity sensor | Timer|
|D400LVHS||100mm | Humidity sensor | Pull cord | Low voltage (SELV 12V)|
|D400LVHT||100mm | Humidity sensor | Timer | Low voltage (SELV - 12V)|
|Max Extract (m³/h)||Max Extract (l/s)||Supply Voltage (V)||Max Wattage (W)||Noise Levels dB/(A)||Warranty (Years)||Fan Speed (RPM)||Colour||
Max Pressure (PA)
|Max Operating Temp (ºC)||IP Rating|
|Wall / Ceiling Hole||107mm|
These fans are double insulated and do not require an earth. All wiring must comply with current IEE regulations. A double pole isolating switch, having a contact separation of at least 3mm in all poles, must be used with a 3 amp fuse fitted and mounted a minimum of 1.75 metres from the floor and less than 400mm from the ceiling.
Do not install the fan above a heat source. e.g. radiator
Single phase induction motor with pre-oiled bearings fitted for a long maintenance free life and protected by a thermal fuse.
The 230V (A.C. 50Hz Single phase consuming 20 Watts) and 12V fans are designed to be wall, window or ceiling mounted. Kits available on request.
Wall kits comprise a wall sleeve (275mm long) and a gravity grille (white, terracotta, stone, grey or brown).
Window kits comprise an external white fixed grille and internal fixing plate.
Ceiling kits comprise 3m of 100mm flexible ducting and an external fixed grille (colours to suit).
When installing through a wall a 107mm hole is required, 126mm through a window.