Heat Recovery Units - Single Room

Download & print PDF page

Heat Recovery Units - Single Room The heat recovery units for single rooms have been specifically designed to eliminate excessive moisture and so helping to prevent condensation with the inherent risks to property and health whilst retaining up to 80% of heat contained within the outgoing air.

The range is available in 230v or 12v models depending upon installation criteria. All models run continuously on trickle speed and have various options to change to fast speed - see model table below. Mounting Kits Available in Brown, White, Terracotta and Stone.

All units are manufactured to have balanced airflow so as not to interfere with conventional gas boilers / heating systems where negative air pressure within a problem may cause a problem.

	Wall, Window or Ceiling mounted
	Integral Humidity Sensors
	Energy saving manual Pullcord override
	Two year no quibble guarantee
	Recovers up to 80% of heat that would otherwise be lost
	Simple Installation

Technical Data

230v models

Catalogue No. Type

HR 100 2-speed, selectable upon installation

HR 100 S 2-speed, pull switch boost

HR 100 HS 2-speed, humidity sensor and pull switch boost

Low Voltage 12v models

Catalogue No. Type

HR 100 LV S low voltage 2-speed, boost by remote switch (not supplied).

HR 100 LV T low voltage 2-speed, pull switch boost

HR 100 LV HTS low voltage 2-speed, humidity sensor / timer or pull switch boost

Construction
These units are made of strong and durable self-extinguishing plastic for strength, durability and finish.

Electrical
220-230v ~ A.C. 50Hz Single phase consuming 15 - 40 watts. These units do not require an earth. All wiring must comply with current IEE regulations. A double pole isolating switch, having a contact separation of at least 3mm in all poles, must be used with a 3 amp fuse fitted.

Installation

Both 230v and 12v ranges are designed to be wall, window or ceiling mounted. Kits available on request.

Installation through a wall or ceiling requires a 117mm hole, through a window a 126mm hole.

Do not install above a heat source e.g. cooker, radiator.

It is recommended to change the internal filter on a yearly basis.

Additional Data

Maximum Pressure: 30Pa low speed, 80Pa high speed

Power Consumption: 15 – 40W

Sound Volume: 15dBa low speed, 35dBa high speed

Maximum Operating Temperature: 55 degrees C

Protection rating: IPx4

Running Costs: typ less than Ł1.00 per month (based on slow speed running 24 hours per day)

Heat Recovery Units - Single Room

** see note above on extract air volumes

Heat Recovery Units - Single Room

Back to the top
< < Previous page Download & print PDF page print this HTML page

Ferrob Ltd.
Regency House, Kingsclere Park, Kingsclere, Newbury, Berks. RG20 4SW
Tel: 01635 299266 Fax: 01635 299277
Email: sales@ferrob.co.uk

Click here to go to our accreditations page, where you can download backup documentation
Click here to go to our accreditations page, where you can download backup documentation
Powered by Multiplex Internet Services Last updated 24 August 2010 S

Catalogue No.	Type
HR 100	2-speed, selectable upon installation
HR 100 S	2-speed, pull switch boost
HR 100 HS	2-speed, humidity sensor and pull switch boost

Catalogue No.	Type
HR 100 LV S	low voltage 2-speed, boost by remote switch (not supplied).
HR 100 LV T	low voltage 2-speed, pull switch boost
HR 100 LV HTS	low voltage 2-speed, humidity sensor / timer or pull switch boost